2.Use the included six bolts, washers, and nuts to assemble the tilting mechanism. (Refer to Figure 2.)

a.Install a bolt, washer, and nut where each tilt arm attaches to the bottom of the wall mount bracket.

b.Install a bolt, washer, and nut on each tilt adjustment mechanism where it attaches near the middle of the wall mount bracket.

c.Finally, install a bolt, washer, and nut where the tilt adjustment mechanism attaches to the tilt arm. Attach so the tilt arm is completely upright (0 degrees in Figure 2) for attaching the monitor.

NUT

BOLT

10°

15°

20°

Figure 2. Tilt Angle

C2230M (2/07)

7

Page 7
Image 7
Pelco C2230M manual Tilt Angle