C2234M (2/07) 3
Installation
To install the IS90-PW/IS90B-PW pendant wall mount, complete the following steps:
1. Run 24 VAC power, video (coaxial or UTP), and camera control wiring to the mounting location.
If you are using coaxial video, do not attach a BNC connector to the cable until step 5.
2. Thread the 24 VAC power, video (coaxial or UTP), and control wiring through the large access
hole in the adapter plate. Then attach the adapter plate to the mounting surface using either
the top/bottom or left/right pair of mounting holes. (The top/bottom pair is shown in Figure1.)
NOTE: If mounting to anything other than a junction box, select appropriate mounting hardware for
the mounting surface
.
Figure 1. Mounting the Adapter Plate