Pelco C2407M-G (5/03) IMPORTANT

[ 4 ] Pelco Manual C2407M-G (5/03)

1. Installation and servicing should be done only by qualified service personnel and conform to all local

codes.

2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6 or 6P enclosure, it is

designed for indoor use only and must not be installed where exposed to rain and moisture.

3. Use only installation methods and materials capable of supporting four times the maximum specified

load.

4. Use stainless steel hardware to fasten the enclosure to outdoor surfaces.

5. To prevent damage from water leakage when installing an enclosure outdoors, apply sealant around

the bolt holes between the enclosure and mounting surface.

The 100 Series Camclosure® Integrated Camera System is a surface-mount dome incorporating a

camera and lens package into a small, discreet, high-security enclosure designed for indoor/outdoor

areas that are subject to heavy vandalism.

1. Cut a small hole in the ceiling or wall for

power and video wiring. Use the adapter

plate as a template.

2. Pull video and power wires into the base,

and attach the base to the wall or ceiling

(hardware not supplied). The electrical

opening in the base will accept a 3/4-inch

(1.91 cm) conduit fitting.

MOUNTING

HARDWARE

(NOT SUPPLIED)

WALL OR

CEILING

BASE

CONDUIT

PLUG

SET SCREW

IMPORTANT

To maximize

tamper

resistance

when not

using the

side conduit

opening for wire

connections, verify that the

conduit plug and set screw are tight.