[ 6 ] Pelco Manual C2407M-G (5/03)
3 Install Camera
1. Some indoor installations do not require a heater. If the
installation does not require a heater, remove the heater
board from the camera assembly. To remove the heater
apply pressure and press on the corner of the board.
2. If the heater is installed, plug the heater connector
from the camera into the mating connector inside
the base. Plug the video connector from the
camera into the mating connector inside the base.
Turn on power to the camera and monitor.
3. If you have a varifocal lens, hold the assembly in
your hand and point the lens toward what you want
to view. Loosen the focal length and focus locking
screws. Adjust according to scene detail. Retighten
the screws.
4. Always make sure the tab on the camera bracket is pointing out of the enclosure (away from
the ceiling or wall). Gently squeeze the bracket, place it against the shoulder inside the base,
and gently release.
Proper camera orientation:
Heater elements could be hot! When camera power is on, use caution when
adjusting the camera. This applies to all models.
CAUTION
HEATER
BOARD
VIDEO
CONNECTOR
HEATER
CONNECTOR
CAMERA BRACKET
TAB ALWAYS POINTS
OUT OF THE
ENCLOSURE
TOP OF
CAMERA
1089
Wall Mounting – The camera
bracket tab points out of the enclosure
and the top of the camera points up
towards the tab.
Ceiling Mounting – The camera
bracket tab points out of the enclosure
and the top of the camera is pointed in
the opposite direction.
CAMERA BRACKET
TAB ALWAYS POINTS
OUT OF THE
ENCLOSURE
1096