Sun Microsystems 6900, 3900 manual Sun Proprietary/Confidential Internal Use Only

TABLE B-2Sun StorEdge Network FC Switch Error Messages (Continued)

Source of Error Message	Cause of Error Message	Suggested Corrective Action
checkswitch	• The current configuration on	1.	Select View Logs or see $LOGFILE
	$switch does not match the defined		for more details.
	configuration.	2.	Rerun setupswitch on the
	• One of the predefined static switch		specified $switch.
	configuration parameters that can be
	overridden for special configurations
	(such as NT connect or cascaded
	switches) is set incorrectly.
checkswitch	The other back-end switch is not the	Run the following command on the
	same type as this switch. Firmware	other back-end switch to upgrade it:
	should be upgraded or downgraded	setswitchflash -s switch2 -f
	so the two switches match.	/usr/opt/SUNWsmgr2/firmware/S
		ANbox1/16040233.fls
checkswitch	No active zone set found.	1.	Attempt to activate an existing
(2 Gbit switches)			zone set.
	2 Gbit switches have a zone	2.	/opt/SUNWsecfg/flib/sanbox2
modifyswitch	configuration with a zoneset and		-x switchip
(2 Gbit switches)	zone(s). Each zone then has port or		get_zoneset_list
	WWN members. 1 Gbit switches had	3.	From that list, select the zoneset
saveswitch	numbered hard zones only.		you want to be active. It should be
(2 Gbit switches)			named something similar to
			hostname_sw1a_zset
		4.	/opt/SUNWsecfg/flib/sanbox2
			-x switchip
			activate_zoneset zoneset
		5.	If you are still having problems,
			rerun setupswitch.
		6.	Rerun the initial command you
			attempted to run.
restoreswitch	Map file format or version is invalid	1.	cp
	for switch type found. User must		/opt/SUNWsecfg/etc/
	have upgraded or changed out the		”switch”.map
	switch with a different type and did		/opt/SUNWsecfg/etc/
	not use the SUNWsecfg commands to		”switch”.save
	reconfigure.	2.	Run saveswitch -s switch
		3.	Manually edit the configurable
			items in the
			/opt/SUNWsecfg/etc/
			”switch”.map file to valid values
			that equal the values in
			“switch”.save file.
		4.	Rerun restoreswitch -s
			switch.

Appendix B Configuration Utility Error Messages 169

Sun Proprietary/Confidential: Internal Use Only