Sun Microsystems 6900, 3900 manual Sun Proprietary/Confidential Internal Use Only

TABLE B-3Sun StorEdge T3+ Array Error Messages (Continued)

Source of Error Message	Cause of Error Message	Suggested Corrective Action
checkt3mount	• The $lun status reported a bad or	1.	Run the showt3 -ncommand to
	nonexistent LUN.		verify that the requested LUN
	• While checking the configuration		exists on the Sun StorEdge T3+
	using the showt3 -ncommand,		array.
	operations abort.	2.	Confirm that the Sun StorEdge
			T3+ array configuration matches
			standard configurations.
createt3group	User-specified LUN $lun does not	Create the required slice or LUN
	exist on the Sun StorEdge T3+ array.	before you set permissions using the
		createt3slice command.
createt3group	Unable to set permissions on the	Refer to the Sun StorEdge T3 and T3+
	LUN $lun to $perm for new group.	array documentation.
createt3group	Error while resetting permissions on	Refer to the Sun StorEdge T3 and T3+
	LUN $lun to NONE for group	array documentation.
	$group.
delfromt3group	Error deleting the world wide name	Refer to the Sun StorEdge T3 and T3+
	(WWN) $wwn from group.	array documentation.
enablevolslicing	Error checking the Sun StorEdge T3+	1.	Check the Sun StorEdge T3+ array
	enable volume slicing status.		firmware level and verify it is
			2.01.00 or higher.
		2.	Check if volume slicing is
			supported and enabled on the Sun
			StorEdge T3+ array.
enablevolslicing	Cannot enable volume slicing. The	1.	Check the Sun StorEdge T3+ array
	Sun StorEdge T3+ array firmware		firmware level and verify it is
	does not support this feature.		2.01.00 or higher.
		2.	Upgrade the firmware, if required.
modifyt3config	• The lock file clear waiting period	1.	Check to see if any secfg T3+
	expired.		commands are being executed.
	• The creatediskpools command	2.	If the commands are executing,
	aborted.		wait for them to complete.
		3.	Run creatediskpools -n
			t3name.
restoret3config	• An error occurred while the block	Run the restoret3config
	size compare command was	command.
	executing.
	• The Sun StorEdge T3+ array block
	size parameter is different from the
	snapshot file. The Sun StorEdge T3+
	array may have been reconfigured.

Appendix B Configuration Utility Error Messages 173

Sun Proprietary/Confidential: Internal Use Only