Sun Microsystems 3900, 6900 manual Sun Proprietary/Confidential Internal Use Only

TABLE 8-1Storage Automated Diagnostic Environment Event Grid for the Sun StorEdge T3+ Array

Component	Event Type	Severity	Action	Description		Action
disk	State	Red	Y	The Sun StorEdge T3+	1.	Open a Telnet session
	Change-			array has reported that a		to the affected Sun
				disk has failed.		StorEdge T3+ array.
					2. Verify the disk state
						with vol_stat,
						fru_stat, and
						fru_list.
					Drive Status Messages:
					0 Drive mounted
					2 Drive present
					3 Drive is spun up
					4 Drive is disabled
					5 Drive has been
					replaced
					7 Invalid system area on
					drive
					9 Drive not present
					D Drive disabled; is
					being reconstructed
					S Drive substituted
					3. Replace the disk if
						necessary.
interface.	State	Red	Y	The Sun StorEdge T3+	1.	Open a Telnet session
loopcard	Change-			array has indicated that		to the affected Sun
				the loopcard is no longer		StorEdge T3+ array.
				in an optimal state.	2.	Verify loopcard state
						with fru stat.
					3.	Verify matching
						firmware with other
						loopcard.
					4.	Reenable the
						loopcard, if possible
						with: (enable
						u(encid)[12])
					5.	Replace the loopcard,
						if necessary.

104 Sun StorEdge 3900 and 6900 Series 2.0 Troubleshooting Guide • March 2003

Sun Proprietary/Confidential: Internal Use Only