Sun Microsystems 6900, 3900 manual Sun Proprietary/Confidential Internal Use Only

Models: 6900 3900

1 204
Download 204 pages 8.57 Kb
Page 185
Image 185
TABLE B-1Virtualization Engine Error Messages (Continued)

TABLE B-1Virtualization Engine Error Messages (Continued)

Source of Error Message

Cause of Error Message

Suggested Corrective Action

 

 

 

Common to

After resetting the virtualization

Check the IP address and netmask

virtualization engine

engine, the $VENAME is

that has been assigned to the

 

unreachable.

virtualization engine hardware.

 

The hardware might be faulty.

Be aware that the machine takes

 

 

approximately 30 seconds to boot

 

 

after a reset.

 

 

 

Common to

• The device-side operating mode is

1. Log in to the virtualization engine

virtualization engine

not set properly.

 

and verify that the device, host,

 

• The device-side UID reporting

 

and network settings are correct.

 

scheme is not set properly.

2.

Make sure the virtualization

 

• The host-side operating mode is

 

engine hardware is not in ERROR

 

not set properly.

 

50 mode.

 

• The host-side LUN mapping mode

3.

If required, power cycle the

 

is not set properly.

 

virtualization engine hardware, or

 

• The host-side Command Queue

 

disable the host side switch port.

 

Depth is not set properly.

4.

Run the setupve -n ve_name

 

• The host-side UID distinguish is

 

command and enable the switch

 

not set properly.

 

port.

 

• The IP is not set properly.

 

 

 

• The subnet mask is not set

 

 

 

properly.

 

 

 

• The default gateway is not set

 

 

 

properly.

 

 

 

• The server port number is not set

 

 

 

properly.

 

 

 

• The host WWN Authentications

 

 

 

are not set properly.

 

 

 

• The host IP Authentications are not

 

 

 

set properly.

 

 

 

• The Other VEHOST IP is not set

 

 

 

properly.

 

 

 

 

 

checkslicd

The virtualization engine cannot

Run startslicd -n ${vepair}.

 

establish communication with the

 

 

 

${vepair}.

 

 

 

 

 

 

checkslicd

The virtualization engine cannot

1.

Determine the host name

 

establish communication with the

 

associated with ${initiator}

 

virtualization engine pair

 

by using the showvemap -n

 

${vepair} initiator

 

${vepair} -f command

 

{$initiator}.

 

output.

 

 

2.

Run the command resetve -n

 

 

 

vename.

 

 

 

 

Appendix B Configuration Utility Error Messages 165

Sun Proprietary/Confidential: Internal Use Only

Page 185
Image 185
Sun Microsystems 6900 Sun Proprietary/Confidential Internal Use Only, Appendix B Configuration Utility Error Messages