Sun Microsystems 6900, 3900 manual Sun StorEdge T3+ Array Partner Group Error Messages

Sun StorEdge T3+ Array Partner Group Error Messages

Caution –Running restoret3config(1M) or modifyt3config(1M) destroys all data on the Sun StorEdge T3+ array.

TABLE B-3Sun StorEdge T3+ Array Error Messages

Source of Error Message	Cause of Error Message	Suggested Corrective Action
Common to Sun	• The current configuration does not	1.	Check the current Sun StorEdge
StorEdge T3+ array	match the reference (standard)		T3+ array configuration with the
	configurations.		showt3 -n <t3> command.
	• This particular configuration is not	2.	Verify whether the configuration
	a standard, supported type.		is corrupted or has changed.
		3. Refer to the raid.cfg files in
			/opt/SUNWsecfg/etc to
			determine if the configuration
			commands are set up and
			functioning properly.
Common to Sun	• Could not mount volume	1.	Replace the failed FRUs.
StorEdge T3+ array	$volume	2.	Restore the Sun StorEdge T3+
	• $lun config does not match		array configuration with the
	• The LUN might have multiple		restoret3config -f -n
	drive failures or corrupted data or		t3_name command.
	parity.
Common to Sun	• No volumes exist on this Sun	Create and restore the Sun StorEdge
StorEdge T3+ array	StorEdge T3+ array.	T3+ array LUNs using
	• $volume volume not found on	restoret3config(1M) or
	this Sun StorEdge T3+ array.	modifyt3config(1M).
Common to Sun	• The $fru status is not ready or	The disk, controller, or loop interface
StorEdge T3+ array	enabled.	card in the Sun StorEdge T3+ array
	• Operations on the Sun StorEdge	might be faulty. Replace the failed
	T3+ array are being aborted.	FRU and rerun the utility.

Appendix B Configuration Utility Error Messages 171

Sun Proprietary/Confidential: Internal Use Only