Sun Microsystems 6900 Sun Proprietary/Confidential Internal Use Only, Value Description, encid12

TABLE 8-1Storage Automated Diagnostic Environment Event Grid for the Sun StorEdge T3+ Array

Component	Event Type	Severity	Action	Description		Action
interface.	Alarm-	Red	Y	The Sun StorEdge T3+	1.	Open a Telnet session
loopcard.cable				array has reported that a		to the affected Sun
				loopcard is in a failed		StorEdge T3+ array.
				state.	2.	Verify the loopcard
						state with fru stat.
				Possible Drive Status	3.	Verify the matching
				Messages:		firmware with the
						other loopcard.
				Value Description	4.	Reenable the loopcard
				0 Drive mounted		if possible (enable u
				2 Drive present		(encid)[12] ).
				3 Drive is spun up	5.	Replace the loopcard
				4 Drive is disabled		if necessary.
				5 Drive has been	6.	Reenable the disk if
				replaced		possible
				7 Invalid system area on	7.	Replace the disk, if
				drive		necessary.
				9 Drive not present
				D Drive disabled; drive is
				being reconstructed
				S Drive substituted
power.battery	Alarm-	Red	Y	The state of the batteries	1.	Open a Telnet session
				in the Sun StorEdge T3+		to the affected Sun
				array is not optimal.		StorEdge T3+ array.
					2.	Run refresh -s to
				Possible causes are:		verify the battery
				• The voltage level on		state.
				the power supply and	3.	Replace the battery, if
				the battery have moved		necessary.
				out of acceptable
				thresholds.
				• The internal power
				cooling unit (PCU)
				temperature has
				exceeded acceptable
				thresholds.
				• A PCU fan has failed.

Chapter 8 Troubleshooting the Sun StorEdge T3+ Array Devices 97

Sun Proprietary/Confidential: Internal Use Only