INSTALL THE BACK BOX
REMOVE THE LOWER DOME
Loosen the
INSTALL THE BACK BOX
The installation methods for the ICS150 back box include the following:
•Attach Directly to a Wall/Ceiling
•Attach to a 4S Deep Electrical Box
•Install in a Ceiling Tile
Select the best method for your installation, and then refer to the following pages for instructions.
Attach Directly to a Wall/Ceiling
Refer to Figure 1 for the following steps.
1. | Cut a hole 3.5 inches (9 cm) in diameter in the ceiling or wall using the adapter plate as a | ||||
| template. |
|
|
| |
2. | Connect the video cable. |
|
| ||
3. | Connect the power wires. |
|
| ||
|
|
|
|
|
|
|
| Voltage | Red Wire | Black Wire |
|
|
| 12 VDC | + | Ground |
|
|
| 24 VAC | ~ | ~ |
|
| AC Operation Only – If you are wiring more than one Camclosure system to the same | ||||
| transformer, connect one side of the transformer to the red wire on all units, and connect the | ||||
| other side of the transformer to the black wire on all units. Failure to connect all of the units | ||||
| the same way will cause the cameras to be out of phase with each other and may produce a | ||||
| vertical roll when switching between cameras. | ||||
4. | Attach the back box to the wall/ceiling. | ||||
MOUNTING |
HARDWARE |
(NOT SUPPLIED) |
WALL OR CEILING
BACK BOX
Figure 1. Installation Directly to Wall/Ceiling
5 |
