Attach to a 4S Deep Electrical Box
Refer to Figure 2 for the following steps. The installation instructions assume that the 4S box was previously installed.
1. | Attach adapter plate to the 4S box with the two | |||
2. | Connect the video cable. |
|
| |
3. | Connect the power wires. |
|
| |
|
|
|
|
|
| Voltage | Red Wire | Black Wire |
|
|
|
|
|
|
| 12 VDC | + | Ground |
|
|
|
|
|
|
| 24 VAC | ~ | ~ |
|
|
|
|
|
|
| AC Operation Only – If you are wiring more than one Camclosure system to the same | |||
| transformer, connect one side of the transformer to the red wire on all units, and connect the | |||
| other side of the transformer to the black wire on all units. Failure to connect all of the units | |||
| the same way will cause the cameras to be out of phase with each other and may produce a | |||
| vertical roll when switching between cameras. | |||
4. | Attach the back box to the adapter plate with the four |
4S DEEP ELECTRICAL BOX
8.32 X .750 SCREW (SUPPLIED)
8.32 X .375 SCREW (SUPPLIED)
WALL OR
CEILING
ADAPTER PLATE
BACK BOX
Figure 2. Installation to 4S Deep Electrical Box
6 |