Pelco C2461M-A manual Reinstall The Dome And Trim Ring, Dome and Trim Ring Installation

REINSTALL THE DOME AND TRIM RING

Place the trim ring and dome over the back box. If the dome has a liner, position the viewing window over the lens of the camera. Tighten the tamper-resistant screws with the supplied 1/8-inch hollow screwdriver bit. Note that the screws are installed at an angle.

Figure 6. Dome and Trim Ring Installation

This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures for recycling this equipment.

C2461M-A (7/03) 13