Amana AKS3020 owner manual Testing for Gas Leaks, Place Grates and Burner Caps, Correct, Too large

Testing for Gas Leaks

!WARNING

To avoid property damage or serious personal injury, never use a lighted match to test for gas leaks.

After final gas connection is made, test all connections in gas supply piping and cooktop for gas leaks.

1.Place soap suds on connection.

• Bubbles appear if leak is present.

To make sure cap is properly aligned and leveled, move burner cap around on burner base. Pegs in the burner base fit into recess in underside of burner cap. Burner cap must be correctly seated on burner base for proper operation of burner.

Make sure proper cap size is on each burner base. Burner does not burn properly if wrong size burner cap is placed on burner base.

Turn on burners to check for proper operation. See Operating Surface Burners section for burner operating instructions.

Correct

Testing for Gas Leaks

2.Tighten joint if leak is at factory fitting.

•If leak is not at factory fitting, unscrew, apply more joint compound, and tighten to correct leak.

3.Retest connection for leak after tightening.

•Retest any connections that were disturbed.

Place Grates and Burner Caps

A

B

C

A—Burner grate

B—Burner cap

C—Burner base

Place Grates and Burner Caps

Not centered Too small Too large

Burner Caps

Electrical Installation Requirements

Installation of this product must conform with local codes or in absence of local codes, with current Canadian Gas Installation Code CAN/CGA-B149.2. If an external electrical source is used when appliance is installed, it must be electrically grounded in accordance with local codes or, in absence of local codes, with current National Electrical Code ANSI NFPA 70, or CSA Standard C22.1, Canadian Electrical Code, Part 1.

All electrical connections are to be made in accordance with CSA Standards Z240.6.1 electrical requirements for mobile homes.

9