Converting Type 1 Pressure Regulator for Use with LP/Propane
This cooktop arrives from factory adjusted for use with natural gas. If using LP/propane gas, cooktop must be converted.
1.Remove pressure regulator cap using 5/8" wrench.
2.Remove plastic insert from pressure regulator cap.
•Plastic insert fits tightly in cap.
3.Reverse plastic insert and carefully push plastic insert firmly into hole in pressure regulator cap.
•Insert must show “LPG10” or “LP10”.
4.Place pressure regulator cap on pressure regulator and tighten.
•Insert should not disturb spring in body of regulator.
B
A
C
Type 1 Pressure Regulator
Converting Type 2 Pressure Regulator for Use with LP/Propane
1.Remove pressure regulator cap using wrench.
2.Reverse pressure regulator cap.
• Cap must show “LP”.
3.Place pressure regulator cap on pressure regulator and tighten.
Cap 
LP 
Converting Burners for Use with LP/ Propane
1.Remove control knobs, grates, caps, and burner bowls.
2.Remove burners by removing burner screw with phillips screwdriver. Unplug burners from burner wires.
3.Lift maintop off burner box to expose air shutters.
• Orifice hoods will be visible.
A
BC
1/8" nominal
Converting Burners for Use with LP/Propane
4.Turn orifice hoods clockwise approximately 11/2 to 2 turns (close) until snug against pin.
•Do not overtighten hoods to avoid damaging hoods.
5.Reassemble cooktop.
6.Adjust burner flame if necessary.
•See “Adjusting Surface Burner Flame” section.
Converting Type 1 Pressure Regulator for Use with Natural Gas
1.Remove pressure regulator cap using a 5/8" wrench.
2.Remove plastic insert from pressure regulator cap.
•Plastic insert fits tightly in cap.
3.Reverse plastic insert and carefully push plastic insert firmly into hole in pressure regulator cap.
•Insert must show “NAT” or be blank.
4.Place pressure regulator cap on pressure regulator and tighten.
•Insert should not disturb spring in body of regulator.
Converting Type 2 Pressure Regulator for Use with Natural Gas
1.Remove pressure regulator cap using 5/8" wrench.
2.Reverse pressure regulator cap.
• Cap must show “NAT” or be blank.
3.Place pressure regulator cap on pressure regulator and tighten.
Type 2 Pressure Regulator
7
