Ethernet Switch | Pelco C2624M instruction

I N S T A L L A T I O N

	FX82012 Unmanaged
®	Ethernet Switch

One 10BASE-T/100BASE-TX Port and

Two 100BASE-FX Fiber Ports

C2624M (6/07)

Image 1

Pelco C2624M manual Ethernet Switch

Contents

Ethernet Switch List of Illustrations Contents RJ-45MDI/MDI-X Connector Pinouts FX Mode Switch SettingsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory Notices Description Product Overview C2624M 6/07 FX82012 module consists of the following series of models ModelsMultimode Models Single-Mode Models*† Illustrates the front panel of the FX82012 module Front Panel Illustrates the rear panel of the FX82012 module Rear Panel Package Contents Installation Flow control is disabled by default Autonegotiation is enabled by defaultFlow control default setting 10BASE-T/100BASE-TX Modes of Operation FX Mode Switch Setting Fiber Failover Mode Mounting Mode of Operation Mounting the FX82012 Module to a Wall PAN Head with Wall Clip Lock Washer Connections Fiber connections Primary Fiber Port Connections in Sample Drop-and-Repeat Application Module Reseat module or power Supply as necessary TroubleshootingReplace power supply Meaning Optic Fault LED on local Section in this table Indication Fefi On local module Optical signalReplace local module By the remote link Meaning Possible Cause Corrective Action Optic Fault LED Amber Table D. Troubleshooting with Rear-Panel IndicatorsIf 10BASE-T operation is Established Meaning Possible Cause Corrective Action Refer to the Setting Duplex mode LinkIf half-duplex mode is Amber Port is set to Full-duplex operation is not Green Port is set to If 100BASE-TX full-duplexFlashing green Port is set to Tion or by manually Table D. Troubleshooting with Rear-Panel Indicators Specifications Wavelength Optical Maximum PowerBudget Multimode 62.5/125 μm Illustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector Pinouts C2624M 6/07 Product Warranty and Return Information ISO9001