C283M-C (4/07)LWM41Legacy® Wall Mount

IMPORTANT SAFETY INSTRUCTIONS

1. Installation and servicing should only be done by qualified service personnel and conform to all local codes.
2. Installation shall be done in accordance with all local and national electrical and mechanical codes utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maximum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.
5. To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply sealant around the bolt holes between the mount and
mounting surface.
The product and/or manual may bear the following marks:
Please thoroughly familiarize yourself with the information in this manual prior to installation and operation.

DESCRIPTION

The LWM41 wall mount is designed for use with all Legacy® Series pan/tilts, giving your installation a very neat and attractive look. All Legacy Series
mounts and optional adapters are finished in a textured gray polyester powder coat to match the pan/tilts and enclosures.
The LWM41 wall mount may be directly attached to any vertical load-bearing structure, and can be used with the PA402 pole mount adapter, the CM400
corner mount adapter, or the PP300L/PP301L/PP4348/PP400 adapter for parapet mounting applications. This mount will support up to 150 pounds (68 kg).
The LWM41 may also be used with an optional integral receiver (refer to Optional Receiver Models on page2).

OPTIONAL ADAPTERS

PP300L Parapet corner adapter mount for LWM41, mounts on rooftops and parapets, rotates 360 degrees, supports 175-pound (79.38 kg) load
PP301L Parapet corner adapter mount for LWM41, mounts to the inside of parapets, rotates 360 degrees, supports 175-pound (79.38 kg) load
PA402 Pole mount adapter for the LWM41, minimum pole diameter 3 inches (7.62 cm), mounting straps not supplied
PP400 Parapet mount adapter, maximum parapet width 16 inches (40.64 cm)
PP4348 Parapet mount for use with LWM41, mounts to rooftop or horizontal flat surface, supports 75-pound (34 kg) load
CM400 Corner mount adapter, supports up to 150 pounds (68 kg)

OPTIONAL ACCESSORIES

LK4500 Optional lock kit for LWM41 wall mount arm access panel
WARNING: This symbol indicates that there are important operating and maint enance instructions in the literature accompanying this unit.