4.Open the hinged door to the back box by pushing the tab lock toward the wall of the unit and lifting the door open.
5.Pull the wiring into the back box through the conduit fitting.
6.Connect all required wiring (refer to Wiring on page 12).
7.Install the back box by compressing the spring clips and pushing the back box through the hole.
8.Tighten the screws until you hear a clicking noise.
HEAVY-DUTY IN-CEILING
1.Prepare the ceiling (refer to Figure 1 on page 8):
a.Locate the center point of the mounting location, and insert the compass tool into the ceiling.
b.Place the end of a pencil in the hole on the end of the compass tool, and draw a circle.
c.Cut out the circle.
2.Use the mounting ring as a template to mark the screw hole pattern onto the mounting surface.
3.Prepare the holes.
Figure 3. Marking the Screw Hole Pattern
4.Install the mounting plates (refer to Figure 4 on page 10). Use the eight
a.Line up the mounting ring with the eight fastener holes.
b.Feed one back mounting plate through the hole in the ceiling. Line up the plate with the four fastener holes.
c.Install fasteners through the mounting ring, ceiling, and out the back mounting plate.
d.Install the second back mounting plate.
C3468M (4/10) | 9 |
