Sample System, Pelco CM9760-IRC | Pelco C538M specification

2.2 SAMPLE SYSTEM

A typical system installation involving the CM9760-IRC might include:

a.	CM9760-CC1	e.	Monitors
b.	CM9760-IRC	f.	Cameras
c.	CM9760-KBD	g.	CM9760-MXBs

d.VCRs

Other Pelco products can be added according to system requirements.

PELCO CM9760-IRC

VCR CONTROL SIGNAL TO

IR LED ASSEMBLY (4 PER IRC DB9)

TO IRC WITH NEXT START ADDRESS

(OR NOT CONNECTED IF IRC IS LAST IN CHAIN)

PELCO CM9760-MXB (VIDEO MATRIX BAY)

VIDEO SIGNAL FROM VCR “OUT” CONNECTOR (ONE PER VIDEO)

VIDEO SIGNAL FROM VCR “IN” CONNECTOR (ONE PER VIDEO)

Figure 3. Sample System Hook-up

6	Pelco Manual C544M (2/98)

Image 7

Pelco C538M manual Sample System, Pelco CM9760-IRC

Contents

D E N D U M CM9760-IRC Infrared VCR Controller Installation C544M 2/98 Contents General Important Safeguards and WarningsProduct and/or manual may bear the following marks CM9760-IRC Rear View Description VCR Hook-up Parameters General Features Pelco CM9760-IRC Sample System Communication Card Installation Control Card Setting the Baud Table B Setting the Start Address VIA Cable Connecting the CM9760-IRC to the CM9760-CC1 Host RS-422 DB9 Port Female OUT Connect VIA Cable Connecting Additional IRCs in Sequence Connecting VCRs to the CM9760-MXB Video Matrix Bay Connecting VCRs to the Video Matrix BAY CM9760-MXB Transmitting VCR Commands VCR Control Signal Outputs Electrical Specifications Specifications Pelco Manual C544M 2/98 Warranty Warranty and Return Information