Pelco C662M-E - page 78

78 C662M-E (5/03)
6. Click Configure.
Figure 93. CM9760-DT Configuration
Table K. CM9760-DT Settings
Term Definition
Baud Rate Set the baud rate according to the data translator settings.
Parity Set the parity according to the data translator settings.
COM Port This is the COM port on the viewstation that the data translator is connected to.
7. Set the baud rate to 4800 and the parity to Even.
8. Enter the COM port that the data translator is connected to on the viewstation.
9. Click OK.
10. Click Test.
NOTE: Once you complete programming, refer to the CM9760-MGR manual for instructions on macro programming for the
matrix switcher. Individual macro commands must be customized within the CM9760-MGR software to switch the appropriate
group of cameras to the monitors connected to the standby DX9000.