2Pelco Manual C907M-A (7/96)
2.0 SCOPE
This manual covers the installation of the following
wireless systems in the WLVEH outdoor enclosure:
WLV500 Series of control systems
WLV2000 Series of video systems
3.0 DESCRIPTION
The WLVEH Enclosure is a NEMA-rated housing that
protects the WLV500 Series of wireless control sys-
tems and WLV2000 Series of wireless video systems
in outdoor environments.
Input power to the enclosure is selectable from either
120 VAC, 24 VAC, or 230 VAC. The AC input is con-
verted to a regulated 15 VDC to power the wireless
system.
The enclosure can be mounted to a flat surface or to a
pole when installed with Pelco's PA102 pole mount,
and PA9000 pole mount adapter.
4.0 INSTALLATION
You can install either a wireless transmtter unit or a
wireless receiver unit in the enclosure. Proceed to ei-
ther Section 4.1, “Transmitter” or Section 4.2, “Re-
ceiver.”
4.1 TRANSMITTER
Refer to Figure 1 to install the wireless transmitter. The
following instructions apply to both the WLV500 and
WLV2000 units.
1. Open the lid of the enclosure.
2. Remove the four screws that secure the transmit-
ter mounting plate (item 11) to the enclosure
mounting plate (15).
3. Install the transmitter to the transmitter mounting
plate so that the electrical connections on the trans-
mitter face the bottom of the enclosure. Use four
small Phillips screws and lockwashers that are sup-
plied with the transmitter.
4. If you have an omnidirectional dipole antenna,
screw it onto the transmitter.
5. Reinstall the transmitter mounting plate (11) in-
side the enclosure. There are two sets of four
mounting holes on the enclosure mounting plate
(15). On units without an omnidirectional dipole
antenna, use the top holes to provide more clear-
ance for making connections to the transmitter.
6. Connect the power leads inside the enclosure to
the transmitter. The red wire attaches to the posi-
tive (+) terminal and the black wire to the nega-
tive (-) terminal.
7. There are two Phillips screws (I) on the bottom of
the enclosure. Nothing is attached to them when a
transmitter is installed in the enclosure.
8. Close the lid.
9. To complete the installation, refer to the instruc-
tions for outdoor installation in your WLV500 or
WLV2000 manual.
4.2 RECEIVER
Refer to Figure 1 to install the wireless receiver. The
following instructions apply to both the WLV500 and
WLV2000 units.
1. Open the lid of the enclosure.
2. Remove the four screws that secure the receiver
mounting plate (item 11) to the enclosure mount-
ing plate (15).
3. Install the receiver to the receiver mounting plate
so that the electrical connections on the receiver
face the bottom of the enclosure. Use four small
Phillips screws and lockwashers that are supplied
with the receiver.
4. Reinstall the receiver mounting plate (11) inside
the enclosure. There are two sets of four mounting
holes on the enclosure mounting plate (15). On
units without an omnidirectional dipole antenna,
use the top holes to provide more clearance for
making connections to the bottom of the receiver.
5. Connect the power leads inside the enclosure to
the receiver. The red wire attaches to the positive
(+) terminal and the black wire to the negative (-)
terminal.