Installation instructions.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for local inspector’s use.
IMPORTANT–OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer: Be sure to leave these instructions with the consumer.
FOR YOUR SAFETY
If You Smell Gas:
1.Open windows.
2.Don’t touch any electrical switches.
3.Extinguish any open flame.
4.Immediately call your gas supplier.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Parts List
Cooktop
■2 twin burner grates
■4 burner caps (1 small, 2 medium, 1 large)
■Gas pressure regulator with attached 1/2″ to 3/8″ reducing bushing and 3/8″ pipe nipple
■2 clamping brackets with screws
■Attached 120 volt grounded plug cord
■Self adhesive gasket 1/4″ x 36″ (1) 3/16″ x 36″ (2)
Downdraft and Blower Unit
JXBA56 motor and blower assembly is required for both models.
■The blower/motor assembly can be located below the cabinet floor. The assembly will fit between 16″ floor joists. Order JXRB57 for indoor remote locations.
–In this installation a transition to 6″ round is required.
■The blower motor assembly can also be installed outdoors. Order JXBC57 for remote blower installation outdoors.
■Downdraft unit
■Downdraft stability brackets
■Two filters
Tools and Parts Needed
■Large flat blade screwdriver
■Saw
■Carpenter’s square
■Pipe wrench
■Manual gas line
■Pipe joint sealant that resists action of LP gas
■Ductwork to suit the installation
For flexible connection where local codes permit:
■Flexible metal tubing (same 3/4″ or 1/2″ I.D. as gas supply line)
■Flare union adapter for connection to supply line (3/4″ NPT x 3/4″ I.D. or 1/2″ NPT x 1/2″ I.D.)
■Flare union adapter for connection to regulator (1/2″ NPT x 3/4″ I.D. or 1/2″ I.D.)
For rigid connection:
■Pipe fittings as required
14
