GE JGP656 Power Supply Locations, Installation instructions, Gas Supply, Electrical Supply

Installation instructions.

Power Supply Locations

Gas Supply:

Electrical Supply:

These cooktops are designed to operate on natural gas at 4″ of water column pressure or on LP gas at 10″ of water column pressure.

■ These cooktops are shipped from the factory set for

natural gas. If you decide to use this cooktop with LP

gas, conversion adjustments must be made by a

service technician or other qualified person. Order

JXLP56 Conversion Kit.

■ The pressure regulator must be connected in series

with the manifold of the cooktop and must remain in

Do not locate gas or electrical connections within shaded area

34"

29-1/2"

4"

Electrical outlet 12″ above cabinet floor

series with the supply line regardless of type of gas

being used.

For proper operation, the maximum inlet pressure to the regulator must be no more than 10″ water column pressure for natural gas and 14″ water column pressure for LP gas.

Gas location

14"

■When checking the regulator, the inlet pressure must be at least 1″ greater than the regulator output setting.

If the regulator is set for 4″ of water column pressure, the inlet pressure must be at least 5″.

If the regulator is set for 10″ of water column pressure, the inlet pressure must be at least 11″.

For ease of installation, and if local codes permit, the gas supply line into the cooktop should be 1/2″ or 3/4″ ID flexible metal appliance connector, three to five feet long.

NOTE: Purchase a new flexible line. DO NOT USE AN

OLD PREVIOUSLY USED LINE.

■Make gas connection through rear wall, or on cabinet floor at rear, as illustrated.

The built-in gas downdraft cooktop features pilotless electric ignition for energy savings and reliability. It operates on a 120 volt, 60 Hz power supply. A separate circuit, protected by a 15 amp time delay fuse or circuit breaker, is required.

■A properly grounded 3-prong receptacle should be located within reach of cooktop’s four foot power cord.

IMPORTANT: (Please read carefully.)

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong grounding wall receptacle to minimize the possibility of electric shock hazard from this appliance. The customer should have the wall receptacle and circuit checked by a qualified electrician to make sure the receptacle is properly grounded and has correct polarity.

Where a standard two-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to have it replaced with a properly grounded three-prong wall receptacle.

Do Not, Under Any Circumstances, Cut Or Remove The Third (ground) Prong From The Power Cord.

Do not use an extension cord.

20