Pelco Manual C1973M-B (8/03) 9
EH2512 SERIES ENCLOSURE INSTALLATIONTo install the MRD1400HZ16 in an EH2512 Series enclosure:
1. Remove the PC board from the MRD1400HZ16. To remove the board:
a. Unscrew the two Phillips button head screws from the unit (refer to Figure 2), and
remove the cover. Discard the screws.
b. Using a small screwdriver, carefully pry each corner of the board from the PEM
studs. Refer to Figure 4.
2. Use the four 4-40 Phillips button head screws (provided) to attach the board to the
DF5/DF8/EH2512 Series adapter.
3. Remove the camera sled from the housing. Refer to the manual supplied with the
EH2512 Series enclosure.
4. Make all required control, power, and camera connections. Refer to Figure 8 and the
Control, Power, and Camera Connections
section of this manual.
5. Refer to Figure 7. Attach the board to the camera sled of the enclosure with the sup-
plied #10 nut and washer.
6. Refer to the manual supplied with the EH2512 Series enclosure to install the camera
and complete the installation.
Figure 7. EH2512 Series Enclosure Installation
DATA IN
CONNECTION
#10 WASHER
#10 NUT
MRD BOARD
01217