10 C579M-A (5/05)
Figure 5.
Sercom Card Mounting Plate Removal
NOTE:
If the VGA card is present in PCI slot 2, remove the retaining screw and gently pull the card up. Reinstall the card into PCI slot 4 (follow
steps d, e, and f, applying them to the VGA card and PCI slot 4).
d. Remove the retaining screw and slot cover for PCI slot 2. Slide the cover out.
e. Install an RP card into PCI slot 1. Carefully align the gold-fingered edge connector of the RP card with the PCI slot. Gently but firmly
press the RP card down until fully seated into the PCI slot.
f. Repeat step e for installing the second RP card into PCI slot 2. Reinstall the retaining screw to secure the RP card into place.
Figure 6.
Sercom/PCI Card Configuration for 88 Ports, Com 2 Available
5. Install the CM9700-ADP-120 adapter plate. Carefully align the plate with the front of the three Sercom cards and the RP card in PCI slot 1
while pushing in toward the CC1 chassis. Secure with mounting plate screws removed earlier. Refer to Figure 7.
1234
SERCOM
CARDS
RP CARDS
VGA CARD