C579M-A (5/05) 9
8. Scroll down to PERIPHERAL SETTINGS, press Enter, and then do the following:
a. Scroll down to ONBOARD SERIAL PORT 2.
b. Change the setting to DISABLED by pressing Page Down.
c. Press Esc.
d. Scroll down to SAVE SETTINGS AND EXIT and type
Y
e. Press Enter.
9. Reboot machine by pressing Ctrl+Alt+Del.
3 SERCOM CARDS, 2 ROCKET PORT CARDS, COM 2 AVAILABLE (88 TOTAL PORTS) 1. Turn off all power to the CC1. Disconnect and label all attached cabling.
2. Remove the top cover mounting screws (refer to Figure 2).
3. From the rear, tilt the top cover up at a slight angle, and then pull backwards away from the front edge to remove the cover from the CC1
chassis (refer to Figure 2).
4. Install the RP cards into the CC1.
a. Remove the screws securing the Sercom card mounting plate (refer to Figure 5).
b. Remove the Sercom card mounting plate by gently pulling outward from the CC1 chassis (refer to Figure 5).
c. Remove the Sercom card from ISA slot 4 by gently pulling up (refer to Figure 3). This card will not be used and should be stored in an
ESD-safe container.
WARNING:
•
Software version 9.03.007 or higher must be installed in the CC1 to enable port expansion ability. If running a previous version, contact Pelco
for software upgrade kit options and availability.
•
Failure to turn off the CC1 power could result in serious damage to the equipment.
•
Electrostatic discharge (ESD) precautions must be observed when performing the procedures described in this manual. Always wear a
gounding strap connected to an approved grounding source when working on or around exposed electronic components.