![](/images/new-backgrounds/1312304/31230417x1.webp)
CAMERA AND LENS
If the camera and lens are already installed, begin with step 2.
1.If applicable, extend the lens to the maximum length before installing the camera in the back box. Attach the camera to the tilt table with the
PENDANT MODEL |
Figure 8. Installing the Camera and Lens
2.For indoor models, connect the power wires and video cable to the camera.
3.For outdoor models, connect the video cable to the camera. Connect the power wires to the circuit board mounted on the side of the back box. Connect the wires to the connectors marked AC IN HI (line voltage), AC IN NT (neutral), and GND.
Attached to the circuit board are a black wire and a red wire with spade lugs on the end; connect these to the power connectors on the camera.
1
2
3
4
5
6
7
8
9
10
HI AC 24 VAC
NT IN INPUT
GND
POWER INPUT | TO CAMERA |
OUTDOOR MODELS |
|
Figure 9. Connecting Camera Power for Outdoor Models
4.Turn on power and adjust the tilt table for desired viewing of the camera on the monitor. Refer to the camera and lens manuals to set up the camera and lens for proper operation.
9 |