Pelco operation manual Warnings, Scope, Description, EA2010 Post Equalizing, Video Amplifier

	®
	EA2010 Post Equalizing
	Video Amplifier
	Installation/Operation
	Manual C630M Rev A (8/90)
1.0 WARNINGS	2.0 SCOPE

Prior to installation and use of this product, the follow- ing WARNINGS should be observed.

1.Installation and servicing should only be done by Qualified Service Personnel and conform to all Local codes.

2.Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is de- signed for indoor use only and it must not be in- stalled where exposed to rain and moisture.

4.Only use replacement parts recommended by Pelco.

5.After replacement/repair of this unit’s electrical components, conduct a resistance measurement between line and exposed parts to verify the ex- posed parts have not been connected to line cir- cuitry.

The information contained within this manual covers the EA2010 Post Equalizing Video Amplifier.

3.0 DESCRIPTION

The Pelco EA2010 provides a low cost, highly effec- tive means of maintaining CCTV picture quality in runs of up to 3000 feet (914.4 m) of RG59 cable.

Through panel controls provided for adjustable overall amplifier flat gain of 1 to +8 dB plus adjustable high frequency boost of 0 dB to greater than 18 dB at 12 MHz, mainlining full video amplitude, contrast and detail.

The EA2010 features all solid-state circuitry and is sup- plied with a U.L. Listed wall transformer. Applications should be for POST-EQUALIZATION only (located near the monitoring equipment); use as a pre-equalizer is discouraged.

Pelco • 300 W. Pontiac Way, Clovis, CA 93612-5699 • USA • (800) 289-9100 or (1-559) 292-1981

FAX (800) 289-9150 or (1-559) 292-3827 • DataFAX (800) 289-9108 or (1-559) 292-0435

International customers call (1-559) 292-1981 or FAX (1-559) 348-1120