Pelco Manual C1464M (6/97) 3
3.0 INSTALLATION
Installation of all EH100 Series camera enclosures requires two (2) 1/4-20 x 1/2
inch screws (not supplied). If you are using a mount, be sure that the mount is
capable of supporting the combined weight of the camera/lens and enclosure.
A 1/4-20 x .375 inch Phillips pan head screw is provided to mount the camera to the
camera sled.
Required Tools:
• Phillips head screw driver
• 1/4 inch tamper-proof socket wrench
To install the camera/lens, complete the following instructions:
1. Remove the tamper-proof screw from the back of the enclosure and separate
the base from the housing.
2. Remove the knockout from the base.
3. Remove the camera sled by first loosening the two screws and sliding the
sled to the large openings.
4. Depending on the application, perform the following steps in the order that
best suits the installation.
a. Attach the camera to the sled using the 1/4-20 screw that came in the
package. If your camera has a low optical centerline or a large diameter
lens you may want to attach the camera to the sled so that the bend in
the sled is up.
b. Attach the enclosure base to the mount using the screws that were pro-
vided with the mount.
c. Slide the camera/camera sled assembly onto the base, make all con-
nections to the camera, and adjust the assembly to fit within the enclo-
sure when assembled. Tighten the screws on the camera sled.
d. Adjust camera/lens, if necessary.
e. Replace the housing and tighten the tamper-proof screw.