CLEANING THE LENS
Follow these steps to clean the projection lens:
1.Apply a
2.Lightly wipe the cleaning cloth over the lens.
3.If you don’t intend to use the projector immediately, replace the lens cover.
| TROUBLESHOOTING |
|
|
Problem | Try these Solutions: |
No power | • Plug the projector into an AC outlet |
| • Turn the MAIN ON/OFF button to ON |
| • Be sure the READY INDICATOR light is ON |
| NOTE: After pressing the LAMP POWER ON/OFF button to OFF. The projector |
| functions as follows. |
| 1. The LAMP POWER indicator will light and the READY indicator will turn off, |
| 2. After one minute, the READY indicator will light green again and the projector may |
| be turned on by pressing the LAMP POWER ON/OFF button. |
| • Check temperature warning indicator. If the indicator flashes red, the projector |
| cannot be turned on. |
| (See “USING THE PROJECTOR” section on page 29). |
| • Check the projection lamp. |
|
|
No image | •Check if computer or video cables are connected to the Projector and the computer or |
| video equipment. |
| • Check the color system. (Video Mode). |
| • Check the computer system. (Computer Mode). |
Image is out of focus | •Adjust the focus. |
| • Make sure the projection screen is at least 3.6 .feet (1.1 m) from the projector. |
| • Check if the projection lens is dark. |
| NOTE: Moving the projector from a cool temperature location to a warm |
| temperature location may result in moisture condensation on the lens. In such |
| an event, leave the projector OFF and wait until condensation disappears. |