8C311M-L (1/05)
Route the wires and cables through the center of the Esprit mount. Reinstall
the transformer module into the base. The transformer module can be
positioned in the mount base in only one orientation.
ES30PC-5/ES31PC-5 Models Only – Set the 120/230 voltage selector switch on the transformer to the appropriate voltage.
Connect wires and cables.
a. Connect to power. Use the two supplied clamp connectors to connect the AC line and neutral.
120/230 VAC 24 VAC
Black wire Input (AC Line) White wire Input (AC Line)
White wire AC Neutral White wire AC Neutral
Green wire Ground Green wire Ground
b. Connect the video coaxial cable to the BNC connector.
c. Connect the wiring for a two-wire or four-wire control system. This step does not apply to Coaxitron® control systems.
Green wire RX-
Red wire RX+
Black wire TX-
White wire TX+
d. Connect AUX 2 (optional). Refer to the schematic drawing for an example of how to wire AUX2.
Orange wire AUX 2
Blue wire AUX 2 COMMON
AUX2 Schematic Drawing
120/230 VOLTAGE
SELECTOR SWITCH
Install mount; refer to the installation manual supplied with the mount for instructions.
AUX 2
AUX 2 COM
AUX 2
AUX 2 COM
D1
1N4005
K1
OMRON G5V-1-DC12 V1
32 VDC
ESPRIT USER
ACCESSORY
NOTE: CURRENT MUST NOT EXCEED 40 mA.
ORANGE WIRE
BLUE WIRE