C311M-L (1/05) 9
Turn on the power. If the red LED lights, turn off the power and proceed to the next step. If the red LED does not light, refer to the
Troubleshooting
section.
Plug the male Esprit system connector, located on the bottom of the pan and tilt, into the female Esprit system connector located on
the transformer module. Align the pan and tilt part number with the alignment label of the base and then attach the pan and tilt to
the base with three 1/4-20 nuts and washers (supplied).
Set the receiver address and system baud rate by configuring DIP switches SW1 and SW2.
NOTE: If you have a Coaxitron controller, you do not have to set the DIP switches. The Esprit will sense and automatically select
settings from Coaxitron control signals in either standard or extended mode.
To set the DIP switches:
a. Remove the plug from the left cover of the pan and tilt. It is not necessary to remove the pan and tilt cover.
b. Set the baud rate (SW1) and receiver address (SW2). For switch settings refer to the labels located on top of the camera
module or Tables A and B in the
Appendix
.
c. Replace the plug.
Refer to the Operation and Programming sections for instructions on how to use your ES30PC/ES31PC Series Esprit Integrated
Positioning System.
PART
NUMBER
ALIGNMENT
LABEL
MALE SYSTEM
CONNECTOR
FEMALE
SYSTEM
CONNECTOR