Pelco C2400M-B, HD3515

C2400M-B (1/06) 7

11. Reinstall the camera and sled.

WARNING:

If the wiring is routed underneath the camera sled, be sure you do not bind the wiring when

reinstalling the camera sled and camera.

12. Close the enclosure lid, and latch.

13. Reconnect power to the enclosure.

Example:

An enclosure that requires 30 VA and is installed 94 feet (28 m) from the transformer

would require a minimum wire gauge of 20 AWG.

NOTE:

Distances are calculated in feet; values in parentheses are meters.

Table A.

24 VAC Wiring Distances

The following are the recommended maximum distances for 24 VAC applications and are calculated

with a 10 percent voltage drop. (Ten percent is generally the maximum allowable voltage drop for

AC powered devices.)

Wire Gauge

20 18 16 14 12 10

Total VA consumed

283 (86) 451 (137) 716 (218) 1142 (348) 1811 (551) 2880 (877)

Maximum distance

from transformer to load

141 (42) 225 (68) 358 (109) 571 (174) 905 (275) 1440 (438)

94 (28) 150 (45) 238 (72) 380 (115) 603 (183) 960 (292)

70 (21) 112 (34) 179 (54) 285 (86) 452 (137) 720 (219)

56 (17) 90 (27) 143 (43) 228 (69) 362 (110) 576 (175)

REVISION HISTORY

Manual # Date Comments

C2400M 6/99 Original version.

C2400M-A 7/99 Revised HD3515 series wattage. Revised Legacy wiring instructions.

C2400M-A 8/99 Revised parts lists. Revised Figure 1.

C2400M-B 2/06 Revised to new format. Added cover photo. Updated per ECO 04-10624, which added PCB cover and ground stud

DLP is a registered trademark of Texas Instruments, Inc.

This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union

regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures for recycling this equipment.