Pelco IS150 manual 4S DEEP ELECTRICAL BOX

4S DEEP ELECTRICAL BOX

NOTE: You should install the camera module into the back box before installing the back box into the surface. When installing the back box into the surface, rotate the camera module to access the mounting holes (refer to Camera Module on page 12 for more information).

1.Attach the supplied adapter plate to the 4S box with two supplied 8-32 x 0.75-inch Phillips flat head screws.

2.Pull video and power wires to the ceiling tile.

3.Connect the video cable/wires:

•BNC: Connect the BNC connector from the unit to a mating BNC connector.

•UTP: Blue wire = Video +

Gray wire = Video -

4. Connect the power wires.

Voltage	Red Wire	Black Wire
12 VDC	+	Ground
24 VAC	~	~

AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.

NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.

5. Attach the back box to the adapter plate with four supplied 8-32 x 0.375-inch Phillips flat head screws.

4S DEEP ELECTRICAL BOX

8-32 X 0.75-INCH PHILLIPS FLAT HEAD SCREW (SUPPLIED)

8-32 X 0.375-INCH PHILLIPS FLAT HEAD SCREW

(SUPPLIED)

WALL OR CEILING

ADAPTER PLATE

BACK BOX

Figure 4. 4S Deep Electrical Box Installation

C3427M-C (10/07) 11