Pelco NSM5200-FANB, DAS5200-FAN manual REPLACING A REAR CHASSIS FAN NSM5200 ONLY

REPLACING A REAR CHASSIS FAN (NSM5200 ONLY)

The NSM5200 has two rear chassis fans that are located on the rear panel of the unit. These fans are hot-swappable and can be replaced without turning off the unit. A red light indicates a fan failure.

1.Turn the two captive thumbscrews counterclockwise to remove the failed rear-chassis fan (refer to Figure 2).

2.Pull the failed fan completely out of the unit.

Figure 2. Replacing a CPU Fan

3.Gently slide the replacement fan into the empty slot.

4.Turn the captive thumbscrews clockwise to secure the replacement fan.

REVISION HISTORY

Manual #	Date	Comments
C4612M	10/09	Original version.
	The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/EC.
	This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union
	regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures for recycling this equipment.

Pelco, Inc. Worldwide Headquarters 3500 Pelco Way, Clovis, California 93612 USA

USA & Canada Tel (800) 289-9100 Fax (800) 289-9150

International Tel +1 (559) 292-1981 Fax +1 (559) 348-1120

www.pelco.com

Pelco and the Pelco logo are registered trademarks of Pelco, Inc. ©Copyright 2009, Pelco, Inc. All rights reserved.