8Pelco Manual C1970M-A (7/01)
CHECK OUT

Table B. Check-Out Procedure

This procedure assumes that power is on.
Step Procedure Results
1Calibrate cameras. Follow the manufacturer’s recommendations for calibration.
2 Press the QUAD/MENU button. See quad display.
3 Press the CH 1 button. See channel 1 image full screen.
4 Press the CH 2 button. See channel 2 image full screen.
5 Press the CH 3 button. See channel 3 image full screen.
6 Press the CH 4 button. See channel 4 image full screen.
7Press the PIP/SEQ button. See PIP display.
8While holding the RESET/ALT button, See each channel image displayed full screen in sequence.
press the PIP/SEQ button.
9Press any channel button, then press the Zoom area is highlighted in the center of the screen.
ZOOM/FREEZE button.
Use arrow keys to move the highlighted area. The highlighted area moves to different parts of the screen.
Press the QUAD/MENU button. The image zooms to show the selected area full screen.
Press the RESET/ALT button. See the selected channel image full screen (normal).
10 Put an object in the area being observed by See the object on the screen. Any movement will be seen.
the selected camera.
While holding the RESET/ALT button, press See the object frozen on the screen. No movement will be
the ZOOM/FREEZE button. seen.
Remove the object from the observed area. The object remains on the screen.
Press the RESET/ALT button. The object disappears and movement is once again seen.
11 Check-out is complete.
OPERATION
The buttons below the screen control the programming and control functions.

DISPLAY

The monitor display can show all cameras in a quad display, show all cameras with one
prominent (picture-in-picture), show only one camera, sequence between all cameras,
zoom, and freeze (refer to Figure 5).

Table C. Display Functions

Function To Activate Press To Deactivate Press
Show all cameras (quad). QUAD PIP, CH1, CH2, CH3, or CH4
Show picture-in-picture (PIP). PIP. Each time you press PIP, the QUAD, CH1, CH2, CH3, or CH4
prominent camera is stepped through
CH1, CH2, CH3, CH4.
Show one camera. CH1, CH2, CH3, or CH4. PIP, QUAD, or another camera
Sequence all cameras. ALT + SEQ. QUAD, PIP, CH1, CH2, CH3, or CH4.
Zoom (works only in single- ZOOM. Use arrow keys (CH1, CH2, ZOOM
camera mode). CH3, CH4) to locate zoom area where
you want it. Then press QUAD to expand
the view. The arrow keys will still function
to move the image area.
Freeze (works in any mode ALT + FREEZE ALT + FREEZE
but zoom). In QUAD and PIP modes next press the
desired camera channel. You can press
more than one channel.