ELECTRICAL CONNECTIONS
Disconnect battery before making any electrical connections.
The power supply for the amplifier must be capable of delivering peak currents up to 50 amps for adequate short circuit protection and reliable operation. The preferred source is directly at the battery. A fuse on the unit protects from overload.
Wire Size and Termination - The diagram shows the minimum wire size used for each connection. If the wire is longer than 10 ft. use the next larger wire size. Use only high quality crimp connectors for installation.
Negative Connection (Black) - Both leads must be used. Connect to negative battery connector or high current buss.
Positive Connection (Red) - Both leads must be used. Connect to positive battery connector or high current buss. A power relay may be used.
Speaker Connection (Brown) - Both leads must be used. Connect 1 lead to each terminal or lead of the speaker.
Optional Radio Input Connection (Blue) - Connect 1 lead to each terminal of the radio speaker or output connector. The input is isolated and polarity is not important. May need to set RADIO VOLUME ADJUST inside the unit.
Optional Auxiliary Input Connection (White) - The Auxiliary Input allows an external source to activate the Siren push button function. Activated by positive or negative input.
#14 AWG RED Use both leads Extend with #12
+
BAT
-
#14 AWG BLK Use both leads Extend with #12
DO NOT USE
CUT CABLE BRN LEADS SHORT
(2) #18 AWG BRN
RADIO
(2)#18 AWG BLU Connect to output jack, terminals or speaker of radio
AUX
#18 AWG WHT
CP2560
CABLE
WIRING HARNESS CONNECTIONS
BLACK TO
BLUE TO TWO WAY RADIO SPKR
BROWN TO SPKR 4K OHM LOAD MIN.
AUTOMOTIVE TYPE FUSE |
20AMP |
WHITE TO AUX |
SIREN SWITCH |
RED TO +VDC |
TB0348A | Page 4 of 7 | 07/12/05 |
