SERVICE
This unit is designed to provide years of reliable service under even the worst conditions. Many times there may appear to be a problem with the unit when the true problem is in the speaker or improper installation. The following chart shows typical symptoms and possible causes.
A blown rear panel fuse doesn't necessarily mean that the unit is bad. If a speaker or speaker lead is shorted this fuse will blow before the unit is damaged. Disconnect the speaker leads and replace the fuse. If the siren emits a sound when in the Yelp position it is OK. Check the speaker or leads for possible shorting.
PROBLEMS
Symptom | Possible Cause | Check |
No Power or siren output | Power switch not turned on | Does backlighting come on? |
| Bad Speaker | Do you hear a “pop” when turned on? |
| Connector or connections loose | With siren on, yelp selected, listen for tone in |
| Rear panel fuse blown | amplifier. |
| Loose connection at power source | Is an external fuse or circuit breaker used? |
|
| Are the power leads connected to a good buss? |
No siren tone – | High Voltage Protection | The input voltage must be less than 16VDC. |
PA works | Mic Button stuck | Does Mic Button release properly? |
No PA | PA volume not set properly | Try turning the PA volume control. |
| Function switch in Radio | PA is not available in Radio position. |
Distorted siren sound | Intermittent Aux Input connection | Is the Aux Input used and wired properly? |
| Low voltage | The input voltage must be greater than 10VDC. |
Intermittent siren tone | High Voltage Protection | Is the battery voltage staying below 16VDC? |
| Connector loose | Is the connector tight on the back of the unit? |
| Loose connection at power source | Check for loose leads back to power source. |
| Mic Button activation | Is something lying on the microphone? |
| Circuit breaker in supply | Is a circuit breaker used with at least 50A rating? |
| connection |
|
Horn or manual stuck on | Siren switch stuck | Does the Siren pushbutton switch return fully when |
| Aux Input improperly connected | released? |
|
| Is the Aux Input used and wired properly? |
No Radio | Unit not connected to a radio | Is the radio connected properly to the unit? |
| Radio volume too low | Can you hear the radio on its own speakers? |
|
| Try adjusting the internal radio volume control. |
RETURN
If you have any questions concerning this or any other Carson product, please contact our Technical Service Department at (888)
If a product must be returned for any reason, please contact our Technical Service Department to obtain a Returned Merchandise Authorization number (RMA#) before you ship the product to Carson. Please write the RMA# clearly on the package near the mailing label. Be sure to provide a return address, contact and phone number, along with a brief description of the problem.
TB0348A | Page 6 of 7 | 07/12/05 |
