GENERAL CARE AND MAINTENANCE
1.Clean o-rings with a soft clean cloth to insure that sealing area is free of dirt that could destroy the o-ring seal.
2.Apply a light coat of clear silicone grease on the o-rings occasionally if turning action becomes too difficult.
3.Remove the tail cap and wipe the rear threads of the 1910 flashlight body and inside of the tail cap with a soft clean cloth occasionally to avoid intermittent flashlight operation.
CAUTION
To prevent the 1910 flashlight coming on accidentally when the flashlight is stored, remove the batteries. If the 1910 flashlight is turned on while it is in a container, the flashlight can overheat and damage the flashlight or the material of the surrounding area.
SPECIFICATIONS
BULB: LED
Batteries: (1) One AAA alkaline or other equivalent alkaline battery
O-RING MAINTENANCE
Check closely for cuts, scratches, or otherwise damaged o-ring or mating lens lip surface. Remove any dirt or foreign matter from o-ring sealing surfaces. Keep threads, o-ring groove and inside lip of lens lubricated with silicone grease. See Warranty information for replacement of o-ring.
Battery Safety Information
WARNING: HANDLE AND STORE BATTERIES PROPERLY TO AVOID INJURY OR DAMAGE BATTERIES CAN BE DANGEROUS!
Most battery issues arise from improper handling of batteries, and particularly from the use of damaged or counterfeit batteries. Please review the information below to avoid serious injury and/or damage to your property.
Alkaline Batteries
1. For those lights with hazardous location safety approvals for explosive environments please be advised that the safety approval is only valid for the specified battery type manufacturer and, where applicable, brand names that are displayed on the flashlight and/or instructions sheets that are supplied with the light. The use of other battery technologies may reduce the performance of the flashlight and will invalidate the safety approval.
2. Always read the battery manufacturers recommendations for the appropriate use of the battery technology/brand prior to using the flashlight.
3. When replacing the batteries:
a. Replace all the batteries at the same time. b. Do not mix battery brands and old and new batteries.
c. Always insert batteries correctly with regard to polarity
(+ and -) marked on the battery and equipment.
4. Do not change batteries in a hazardous location.
5. Remove batteries from equipment if it is not to be used for an extended period of time.
Always dispose of all batteries properly at an approved battery recycling center.
PELICAN LIMITED LIFETIME GUARANTEE OF EXCELLENCE
Pelican Products, Inc. guarantees its lights for a lifetime against breakage or defects in workmanship. This guarantee does not cover the lamp or batteries. Pelican will either repair or replace any defective product, at our sole option. TO THE EXTENT PERMITTED BY LAW, THE REMEDIES HEREBY PROVIDED SHALL BE THE EXCLUSIVE AND SOLE REMEDY OF THE PURCHASER.
TO THE EXTENT PERMITTED BY LAW: (A) THIS WARRANTY IS IN LIEU OF ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE; AND (B) ALL OTHER IMPLIED WARRANTIES AND ANY LIABILITY NOT BASED UPON CONTRACT ARE HERBY DISCLAIMED AND EXCLUDED.
TO THE EXTENT PERMITTED BY LAW, IN NO EVENT SHALL PELICAN BE LIABLE FOR ANY INDIRECT, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL DAMAGES, OR SPECIAL DAMAGES, REGARDLESS OF WHETHER A CLAIM FOR SUCH DAMAGES IS BASED ON WARRANTY, CONTRACT, NEGLIGENCE OR OTHERWISE. To the extent permitted by law, in no event shall Pelican’s liability to the purchaser for damages hereunder exceed the purchase price of the product in respect of which damages are claimed.
To make a warranty claim, the purchaser must contact Pelican Products, Inc. at 23215 Early Avenue, Torrance, CA 90505 or csrwarranty@pelican.com, or by calling 1-800-473-5422, extension 5. Any warranty claims shall be made by the purchaser as soon as practicable. The purchaser must obtain a return authorization number from Pelican Customer Service prior to returning any product, and is responsible for paying for all warranty freight costs. If Pelican determines that any returned product is not defective, within the terms of this warranty, the purchaser shall pay Pelican all costs of handling, return freight and repairs at Pelican’s prevailing rates.
All warranty claims of any nature are barred if the flashlight has been altered, damaged or in any way physically changed, or subjected to abuse, misuse, negligence or accident.
Some states and countries do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state and country to country.
In Australia: The benefits provided to you under this warranty are in addition to your rights and remedies as a consumer under the Competition and Consumer Act 2010 (Cth). Nothing in this warranty limits the rights or obligations of a party under provisions of the Competition and Consumer Act 2010 (Cth) in relation to the supply to consumers of goods which cannot be limited, modified or excluded. If applicable, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. If you are not a consumer under the Competition and Consumer Act 2010 (Cth), then your rights may be limited. To make a warranty claim, the purchaser must contact Pelican Products Australia, Suite 2.33, West Wing, Platinum Bldg., Erina NSW 2250, Tel: +612 4367 7022.
Any warranty claims shall be made by the purchaser as soon as practicable. The purchaser must obtain a return authorization number from Pelican Customer Service prior to returning any product, and is respon- sible for paying for all warranty freight costs. If Pelican determines that any returned product is not defective, within the terms of this warranty, the purchaser shall pay Pelican all costs of handling, return freight and repairs at Pelican’s prevailing rates. In the event that Pelican determines that any returned product is defective, within the terms of this warranty, Pelican shall pay the purchaser all reasonable costs of the purchaser in making claim under this warranty.
Lifetime Guarantee does not cover Roto Molded cases, AALG products or fabric portion of backpacks. Refer to www.pelican.com/warranty for full details.
PELICANTM PRODUCTS
23215 Early Avenue • Torrance, California 90505 USA Tel 310.326.4700 • FAX 310.326.3311 • www.pelican.com
PELICANTM CANADA
10221-184 St. • Edmonton, Alberta T5S 2J4
Tel 780.481.6076 • FAX 780.481.9586
PELITM PRODUCTS, S.L.U.
c/ Provença, 388, Planta 7 • 08025 • Barcelona, Spain
Tel: +34 934 674 999 • Fax: +34 934 877 393
1913-311-001 5-9157 Rev A
© 2013 Pelican Products NO/13
All trademarks are registered and/or unregistered trademarks of Pelican Products, Inc., its subsidiaries and/or affiliates.
Cat. #1910 PELICANTM
1910
LED
INSTRUCTION MANUAL
This compact flashlight produces an ultra bright light beam by using a LED powered by (1) one AAA 1.5V alkaline battery. The 1910 flashlight is designed for easy use with one hand operation and has a dual-switch mode for constant-on and momentary-on. The 1910 flashlight body is made by high precision CNC machines from aircraft-grade aluminum alloy for the most durable construction. The 1910 flashlight is water resistant.
TO INSERT BATTERY
1.Remove the tail cap by turning counter-clockwise.
2.Install (1) one AAA alkaline battery with + terminal facing to the head assembly.
3.Replace the tail cap onto the flashlight by turning clockwise until sealed.
OPERATION
High > Low > Off 1. MOMENTARY -
Gently depress the tail button for momentary operation.
Press once for high, press again (within a half second) to change from high to low.
2.CONSTANT ON -
• Single click for High
• Three clicks (no more than a half second between clicks) for low
3.LIGHT-OFF -
Press the tail button to turn OFF.
TO CHANGE BATTERY
1.Remove the tail cap by turning counter-clockwise until it comes off the rear of the 1910 flashlight.
2.Remove the (1) one used battery from the 1910 flashlight.
3.Install the (1) one new AAA alkaline battery with + terminal facing to the head assembly.
4.Replace the tail cap by turning clockwise until sealed.
