C. Fold down top flap of water resistive barrier (4C).
D. Apply flashing tape to diagonal cuts. Cut pieces of flashing | 4C |
| |
tape at least 1" longer than the diagonal cuts in the water resistive |
|
barrier. Apply the tape covering the entire diagonal cut in the water | |
resistive barrier at both upper corners of the door. | 4D |
| |
Note: Be sure to overlap the top corners (4D).
5 REINSTALL THE SLIDING PANEL
Exterior
TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE FOLLOWING STEPS.
A.Insert door panel. From the exterior of the building, tilt the top of the panel toward the door frame and insert the top of the door panel into the top track. Move the bottom of the panel toward the door frame until it is vertical. Gently set the panel down into the bottom track.
ProLine only: Install bumpers and the panel retainer. Follow the instructions included in the hardware box.
5A |
Note: Be careful not to pinch your fingers between the two panels. DO NOT close the sliding panel until you have installed the hardware. The door may lock when closed.
B.Install the handles and panel retainer. Follow the instructions included in the hardware box. If the panel is not square to the door frame, adjust the bottom rollers by removing the adjusting hole cover and inserting an 8" long #2 Phillips screwdriver into the hole. Turn clockwise to raise the panel and
C.Install screen. Instructions for installing the screen are found in the screen door package.
6 INTERIOR SEAL
Caution: Ensure use of low pressure polyurethane window and door insulating foams and strictly follow the foam manufacturer’s recommendations for application. Use of high pressure foams or improper application of the foam may cause the door frame to bow and hinder operation.
A.Apply insulating foam sealant. From the interior, insert the nozzle of the applicator approximately 1" deep into the space between the door and the rough opening and apply a 1" deep bead of foam. If using foam other than Great Stuff ™ Window and Door Insulating Foam Sealant by the Dow Chemical Company, allow the foam to cure completely (usually 8 to 24 hours) before proceeding to the next step.
Note: DO NOT completely fill the space from the back of the fin to the interior face of the opening.
Interior
6A
B. Check the door operation by opening and closing the door.
Note: If the door does not operate correctly, check to make sure it is still plumb, level, square and that the sides are not bowed. If adjustments are required, remove the foam with a serrated knife. Adjust the shims, and reapply the insulating foam sealant.
