Pella 80GZ0102 Window Preparation, H. Install and level sill spacers. Place

E.Apply sill flashing tape #1. #UT A PIECE OFImASHING TAPE  A longer than the opening width. Apply at the bottom of the

OPENINGNAS SHOWN % SO IT OVERHANGSA TOSTHEEXTERIOR

Note: The tape is cut 12" longer than the width so that it will extend 6" up each side of the opening.

F.Tab the sill flashing tape and fold. #UT  WIDE TABSIAT EACHT CORNER  FROM EACHESIDE OF CORNER E& F&OLDLTAPE TOATHEE exterior and press firmly to adhere it to the water resistive barrier.



&







'

' Apply sill flashing tape #2. #UT A PIECE OFImASHING TAPE  LONGERITHAN THE OPENING WIDTH

!PPLY ATYTHEABOTTOMHOVERLAPPINGPTAPE GBYYAT LEAST  $/S./4 ALLOWWTHETTAPE TOTEXTEND PAST THE INTERIOR FACE OFETHEIFRAMINGF' 

Note: The flashing tape may not fully cover framing members.

H. Install and level sill spacers. Place

 WIDEWBYY THICK SPACERS ONKTHES BOTTOM OFOTHE WINDOWWOPENINGE from each side. Spacers are also required at points where windows are joined

in multiple window applications. Add shims as necessary to ensure the spacers are level. Once level, attach spacers and shims to prevent movement.

Note: Improper placement of shims or spacers may result in bowing the bottom of the window.



(

)

2WINDOW PREPARATION

A.Remove plastic wrap and cardboard packaging from window.

Note: If screens, grilles or hardware are removed from the window at this time, label them and store them in a protected area.

For installation using installation clips, preceed to Step C.

6" MAX

10"

MAX

10"

MAX

FOR PLACEMENT

OF FRAME

SCREWS AND INSTALLATION CLIPS

B.Windows using frame screws: Pre-drill installation screw holes. On the room side of the window,

DRILLI DIAMETERCLEARANCEA holes through the frame as shown on the placement diagram.

Space the holes a maximum

OF  FROM EACHEENDCAND AE MAXIMUMIOF  ONOCENTER ON the head, jambs and sill.

#

%SJMM


DMFBSBODF
IPMF



$MBE
'SBNF
4JMM

10"

MAX

6" MAX

6"

MAX

10" 10" 6"

MAX MAX MAX

C.Fold out installation fin to 90°. Be careful not to remove or tear the fin corners.

Note: If the fin is not at 90°, the window will not line up correctly on the interior.

D. Windows using Installation Clips: Install installation clips. Place the clip so that the lip is facing up and against the installation fin, at the locations shown in the placement DIAGRAM 3ECUREETHETCLIP BYYDRIVINGI X v CORROSIONI

#6 x 5/8” corrosion resistant screws

Lip

2D

6“ from end

resistant screws through the outer two holes of the three holes shown.