C1. Rectangular window: |
|
Apply top flashing tape. Cut two pieces of flashing tape | $ |
long enough to go across the top of the window and |
|
EXTEND NPAST THE mASHING TAPETON BOTHmSIDES !PPLY |
|
ONENPIECEPOF TAPEELAPPING IT EONTO THE FRAME |
|
cladding, covering the fin and lapping onto the water resistive barrier. Fold the overlapping tape down, and press all tape down firmly. Apply the second piece of tape just above and overlapping THEHlRST PIECE OF mASHINGCTAPE BYY0RESSSTHE tape down firmly.
$
# Angle top window:
Apply top flashing tape. /NNTHETSHORTTSIDE OFDAETRAPEZOIDI window, DO NOT allow the side flashing tape to extend higher than the top tape will cover.
%
&YUFSJPSD. Fold down top flap OFOWATERWRESISTIVEEBARRIERR$
E. Apply flashing tape to diagonal cuts. Cut | & |
PIECES OFEmASHINGFTAPE ATSLEASTN LONGERPTHAN the diagonal cuts in the water resistive
barrier. Apply the tape covering the entire& diagonal cut in the resistive water barrier
at both upper corners of the window.
Note: Be sure to overlap the top corners (4E).Note: If installing the window using installation clips, proceed to Step 6 - Installation Clip Method.
5SECURING THE WINDOW
A.Install a #10 x
Proceed to Step 7.
| #10 x |
| corrosion |
5A | resistant |
| wood screw |
A. Fasten the window to the opening BY DRIVING TWO Gv OR LONGER | 6A | |
CORROSIONIRESISTANT SCREWS INTOITHETPREPUNCHEDNHOLESEIN THE CLIPS )FF | ||
| ||
clips are bent and fastened to the interior stud/block, install the screws |
| |
as close to the bend as possible. |
|
Note: DO NOT shim above the window. For masonry openings use two 3/16” x