2PREPARE THE DOOR FOR INSTALLATION
TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE
THE PANEL AND FRAME SAFELY.
A.Remove plastic wrap and cardboard packaging from door. DO NOT remove plastic shipping spacers. The shipping spacers will help keep the door square during installation. DO NOT open the door until it is fully fastened.
If Attaching with fasteners through the Brickmould go to Step 3 Anchoring Method – (Installation Clip or Frame Screw Through Frame)
B.Doors using Installation Clips: Install installation clips. Place each clip so the lip is facing up and against the brickmould at the locations shown in the placement diagram. Secure each clip by driving a #6 x 5/8" corrosion resistant screw through each of the outer two holes of the three holes shown.
Note: If clips are to be bent;
#6 x 5/8" corrosion resistant screws
Lip
2B
C. Doors using Frame Screws: Open door panels; drill and
diameter clearance holes through the door frame jambs, (head and sill of sidelight units) but not into the rough opening at the locations shown. Where applicable, clearance holes are drilled though open hinge screw holes and each strike hole.
Pilot Hole |
Alternative Pilot Hole |
for Screw Install |
Pilot Hole
Pilot Hole |
Alternative Pilot Hole |
for Screw Install |
Pilot Hole
Pilot Hole
Pilot Hole
DOOR UNIT, JAMB TO JAMB | SIDELIGHT UNIT, HEAD TO SILL | SIDELIGHT UNIT, JAMB TO JAMB |
