3 SETTING AND FASTENING THE DOOR (CONTINUED)
Frame Screw Method:
J.Drill 1/8" x 1" deep pilot holes through the clearance holes and into the rough opening framing in the head, jambs, and threshold of the door frame.
Note: Be certain to shim between jambs and rough opening at all screw locations.
K.Secure the jambs and head of the door. Drive #10 x 3" corrosion resistant wood screws through the door frame and shim, into the rough opening. Drive the screws until snug but DO NOT
Installation Clip Method:
L.Fasten the door to the opening by driving two #8 x
Note: DO NOT shim above the door. For masonry openings use two masonry screws a minimum size of 3/16" x
Frame Screw and Installation Clip Methods:
M. Sidelights of combinations only: Drive # 10 x 3" through each of the holes in the sill. Apply sealant to the screw heads not located at the hinges or strikes.
Note: For concrete floors, use masonry screw a minimum size of 3/16" diameter x 3". Predrill the masonry per screw manufacturer’s recommendations.
N. Check for sufficient weatherstrip contact between the bottom
weatherstrip and the threshold. Close the door on a dollar bill or sheet of paper located above an adjustment screw; light friction should be felt when pulling the
paper out indicating a good seal is3N being made. If there is not, adjust
the threshold. Repeat for each adjustment screw.