Pella 81CM0100 installation instructions Before YOU Start, YOU will Need to Supply

YOU WILL NEED TO SUPPLY:

ŘComposite or Impervious shims/spacers (12 to 20)

ŘHigh quality exterior grade polyurethane or silicone sealant (3 to 4 tubes per door)

ŘGreat Stuff™ Window and Door Insulating Foam Sealant by the Dow Chemical Company or equivalent low pressure polyurethane window and door foam - DO NOT use high pressure or latex foams.

ŘWood blocking, 3/4" x 4" x 96" (2 or 3 pieces) ŘScrews (#10 x 3-1/2")

ŘPella® SmartFlash™ foil backed butyl flashing tape or equivalent.

ŘSill pan

Installation will require two or more persons for safety reasons.

4&"-"/5

TOOLS REQUIRED:

ŘTape measure

ŘLevel

ŘSealant gun

ŘSquare

ŘHammer

ŘScrewdriver

ŘUtility knife

ŘWide jaw pliers

ŘReciprocating saw

Ř1/8" and 1/4" drill bit

ŘDrill

1 BEFORE YOU START

A.Remove the vent panel from the existing door frame. Check the dimensions of the existing door and the new door to make sure the new door will fit correctly. The opening must be 1/2" larger than the new door frame in both width and height. Measurements should be taken as follows:

Width - measure the inside dimension of existing jambs.

Height - measure from the subfloor or cement slab to the lowest point of the existing head. Confirm the flange will overlap the stucco by 1/2".

1A