![](/images/new-backgrounds/1041952/419525x1.webp)
F.Verify that the installation jamb screws will fasten into solid wood. If not, insert solid filler at screw locations.
Note: Raise the lower sash to access the lower installation holes. There will be four or six installation holes in each jamb, depending on the window frame size.
High Performance Installations: Using a
DRILL BITRPREDRILLR DEEPANDINSERTT X XmATHEAD EXTERIORHGRADEDWOOD SCREWS IN ALLLTHE EXTERIOR BLIND STOPSO3CREWS SHOULDHBE PLACED EFROM EACHEENDCAND NOTNMOREETHAN ON CENTER
&95&3*03
w
&YUFSJPS
CMJOETUPQ
3 PREPARE THE WINDOW FOR INSTALLATION
A. Remove packing materials from the window.
Note: Check product for any cracks or penetrations in the frame. DO NOT install damaged windows.
| Î |
| 4JMMBEBQUFS |
B. Install the sill adapter in the sill | 4JMMBDDFTTPSZ |
HSPPWF |
accessory groove.
Note: Use a rubber mallet to drive the sill adapter into the sill accessory groove. The vertical leg of the sill adapter may be cut to accommodate different sill angles.
4 SEALING AND FASTENING THE WINDOW
A.Test fit the window in the opening. With the window closed and locked, set the bottom of the window into the opening, then tilt the top into position.
B.Ensure the window is resting against the interior surface of the blind stops and the sill
adapter meets the original sill. |
| |
Note: The height of the window frame can be |
| |
increased by as much as 3/8" by applying the |
| |
head expander (included) to the window |
| |
frame. If more than 3/8" height adjustment |
| |
is required, install a continuous shim at | { | |
the sill. | ||
|
DO NOT use the head expander in High
Performance installations.
C.Apply the head expander (if required). For installation
USINGITHEGHEAD EXPANDERGO TOO).34!,,!4)/.
).3425#4)/.3)(%!$ %80!.$%2$LATER IN THISEBOOKLET
i
i
D. Drill two 1/4 weep holes INITHE SILL ADAPTER,OCATE THE HOLES vHFROM EACHE
end. The bottom of the weep hole must be at the bottom of the vertical leg of the sill adapter.