indoor temperature reaches the setting. Once the temperature departs the setting, the fan will turn on automatically.
4.TURN-OFF
When the left/right motor is low/medium/high, press the “ON/SPEED1/OFF”/ “ON/SPEED2/OFF” button three times/twice/once, then the left/right speed light is off and the left/right motor stops.
ⅡREMOTE CONTROLLER OPERATION
The remote controller is more convenient than the panel except it cannot be used to set the temperature.
1.Press the “ON/OF”button to start the fan. The two motors will take in the air at the low speed.
2.To change the speed of left/right motor, press “SPEED1”/“SPEED2”button. Repeat and then press to select the speed; the sequence of speed is low, medium and high.
3.To exhaust air, press the “DIRECTION1”/“DIRECTION2”button. Change the air direction by pressing the button repeatedly.
4.To stop the fan, press the “ON /OFF”button.
INSERT THE BATTERIES
Press down on the battery compartment cover and slide it out.
1.Insert the batteries (not included in the package), and make sure that the batteries are placed in the right way.
2.Slide back the battery cover.
Notes: Use size "AAA" alkaline or standard
batteries.
Figure 3
The batteries should be removed from the remote controller and disposed of safely before they are flat.
CLEANING
1.Be sure to unplug from the electrical supply source before cleaning.
2.Plastic parts should be cleaned with mild soap and damp cloth or sponge. Thoroughly remove soap film with clean water.
3.To disassemble each part, reverse the order of assembly.
4.Be sure not to let water or other liquid enter the inside of motor.
5.To clean the filter:
1)Take of the small round plastic plate at the center of the louver by rotating it
2)Use screwdriver to take off the screw and pick up the plastic washer (above) and metal washer.
3)Take the louver and find the filter behind it. Clean them with mild soap and damp cloth or sponge. Thoroughly remove soap film with clean water.
4)When the filter is dry, reverse the assembly order.
