UNPACKING AND SET-UP INSTRUCTIONS
A
C
B
Unpack your heater and remove both halves of the base from the package. Refer to the picture below:
1.Make sure the heater is unplugged and in the “ OFF” position.
2.TURN THE HEATER UPSIDE DOWN. Unfasten the four screws.
3.Fix both halves of the base as shown.
4.Insert the four screws and screw them tightly.
5.Turn the heater upright. Your heater is now ready for use.
CAUTION: Risk of fire – Operate heater in upright position only. Any other position could create a hazardous situation.
OPERATION INSTRUCTIONS
Fig.1 Control Panel View Fig.2 Remote Control Panel View
Fig.1 Control Panel Functions
A |
| Digital Indicator |
| C |
| Timer |
|
|
|
|
|
|
|
BOscillation Switch
Place the heater on a firm level surface free from obstructions, and at least 3 ft. away from any wall and any other objects such as furniture, curtains, plants or combustible material.
Plug the heater into a grounded 120V outlet; the buzzer sounds and the “A” Digital Indicator indicate the room temperature. When the heater is on, every time you press a key, the buzzer will sound.
Press POWER key, the operating mode is switched circularly in sequence of HI
IMPORTANT!
Your heater is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your outlet. DO NOT defeat the safety purpose of the polarized plug.
Carry handle (behind)
Control | Front LED |
panel | |
| display |
FAN: The Fan circulates room air only. The heating elements are “ OFF”.
LOW: The Fan and heating elements operate at 900 Watts.
HIGH: The Fan and heating elements operate at 1500 Watts.
Temperature setting: When the heater is on (HI or LO), press “ Up” or “ Down” key and the Digital Indicator will indicate the last set temperature (75 oF is default setting). You can now adjust your desired temperature by pressing the “ Up” or “ Down” key; the temperature range is
A.If the setting temperature is higher than the room temperature, the heater continues heating until the room temperature reaches the setting temperature. Once the room temperature reaches your setting temperature, the heater will stop heating. The heater will resume heating when the room temperature is lower than the set temperature. The heater will cycle on and off this way to maintain the setting temperature.
