Pentair 710 important safety instructions Setting up the Power Supply, At Least 10 Feet

6

Setting up the Power Supply

WARNING —Risk of electrical shock or electrocution.

A ground fault current interrupter (GFCI) must be in place to protect your electric outlet . Failure to do so could create an electrical hazard which could result in death or serious injury to pool or spa users, installers, or others due to electrical shock, and may also cause damage to property.

The power supply MUST be placed a minimum distance of 10 feet away from the pool. Failure to do so could create an electrical hazard which could result in death or serious injury to pool or spa users, installers, or others due to electrical shock, and may also cause damage to property.

CAUTION — Never power the cleaner “ON” if it is not fully immersed in water.

This cleaner has an internal timer, which will automatically shut off the cleaner after 2 hours of operation. However, the Switch will remain in the “ON” position. To re-start the cleaner for another cycle, switch the Power Supply “OFF”, and then switch it back to the “ON” position and press the Reset Button. See Figure 1.

1.Place the Power Supply in a dry, sheltered area at least 10 feet away from the pool, see Figure 3. Since the Power Supply is water resistant, not water proof, it should not be left out in the rain or placed in puddles of water.

2.PlugthePowerSupplyCordintoa115V,threepronggroundedGFCIoutlet.Ifanoutletisnotcloseenough, a grounded 115V extension cord may be used to connect to the nearest outlet, see Figure 4.

Figure 4.

At Least 10 Feet

Figure 3.

(Remember to keep the Power Supply at least 10 feet away from the pool.)

Prowler™ 710 Installation and User’s Guide