Pentair Automatic Pool Cleaner important safety instructions Reassembly, Bottom View of Cleaner

Reassembly

1. Put both white seals in the oscillator; hold them in place.

2. Install the oscillator on the long gear shaft. Install the ratchet gear on the shaft so that the teeth engage the ratchet on the oscillator. Install the spring, ratchet drum, pinion gear (large gear first), and cam (gear end first) on the shaft (See Figure 28). Hold the gears on the shaft while installing them, and compress the clutch spring to allow assembly to slip into place between the posts (See Figure 28).

3. Install the long gear shaft and end blocks in the cleaning head with the large arm of the cam down (see Figure 29).

4. Reinstall the short gear shaft, set screw and two gears (See Figure 30); the small pinion gears and the shaft set screw go on the side toward the end of the cleaner – away from the oscillator box. Make sure that the gears engage the gears on the long gear shaft.

5. Install the oscillator chamber cap and clip it in place.

6. Install the rubber vacuum skirt on the cleaner with the word ‘OUTSIDE’ showing. Start at the large pin on the back of the cleaner head (see Figure 31) and work around the cleaner. Make sure the skirt is flush against the stop strips on the cleaner head (see Figure 32).

7. Turn the cleaner over. If you removed the bumper and brush ring, replace them now.

8. Install the lower body assembly in the shroud. Fasten the cleaning head in place with 4 screws (2 long, 2 short – see Figure 33).

NOTE: Make sure that you do not dislodge the rubber vac skirt while inserting the lower body assembly past the brush ring.

Seals

Figure 28

Make sure Oscillator is partially inserted in chamber while reinstalling Shaft Assembly

Swing Cam

Arm up for

Clearance

Oscillator

Chamber

Figure 29

1895 0795

17

1894 0795

Not

This

	This
Figure 32	1892 0795
	#10-16x1-3/4" Screws	Lift Brush
		Location
Center		Center
Brush		Brush
Location		Location
	#10-16x1" Screws 1891 0795
Figure 33	Bottom View of Cleaner

Figure 30

Start here with large button when installing vacuum skirt.

'Outside' will show (facing out) when

skirt is correctly installed.

Figure 31

1890 0795

Rubber vacuum skirt

1893 0795

Great White Installation and User’s Guide